Welcome
Welcome to Ranger Dave's Place

You are currently viewing our boards as a guest, which gives you limited access to view most discussions and access our other features. By joining our free community, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content, and access many other special features. In addition, registered members also see less advertisements. Registration is fast, simple, and absolutely free, so please, join our community today!

92 to a 96 4.0

Moderator: soushoreguy

92 to a 96 4.0

Postby Dave » Fri Sep 16, 2011 7:57 pm

the head gasket(i think) went in my 96 4.0 in my 95 ranger. drove it to long,got tooooo hot,oil was WAAAY over full, and dont trust it. SO,i have a 92 4.0(NON EGR).i swapped all the emmisions and wiring over the the 92 motor.

92 intake, NO egr
Image
92 exhaust manifold,no egr
Image
92 dummy distrubuter(on the right),NO cam sensor
Image

i need a whole now cam positioning sensor and housing,the bushing were bad and to much play in the shaft. so i bought a new one. $40 at amazon with a alighment tool :headbang:
new one
Image
alighment tool
Image
tool in place
Image
this is how it sholud look in the engine
Image
so,bring #1cyl up the TDC
Image
install the sensor with tool in place
Image
install the lock down clamp, done
Image
THE TRACTOR,BUILT MY WAY NOT BOUGHT
86 Ranger,D35/8.8,456's all locked,1350/Np205 doubler(83.3crawl), extended raidus arms,2.9/5spd,4in lift, sitting on 33 MK's

WELCOME TO RANGER DAVES PLACE
User avatar
Dave
Site Admin
 
Posts: 1014
Joined: Tue Jan 20, 2009 7:14 pm
Location: Newbury NH
Highscores: 2

Return to Ford 4.0

Who is online

Users browsing this forum: No registered users and 0 guests

cron
suspicion-preferred